It's a little faster and easier than installing Ethereal/WireShark, if not as reliable. If DHCP on the unit has been disabled, I've also had some luck with doing arp -a from the command line after rebooting the computer and router to get the IP address it is using. Then click View network status and tasks in Network and Internet category. On the top right, choose to view by Category. The HomePortals identify computers based on MAC address, so they will tend to keep pulling the same IP address.Īlso, in general, TerryNet's solution works beautifully. Find your Router’s IP address on Windows. I know for example that Qwest uses different settings on their 2700's:Īnything within the subnet that is not part of the DHCP range is available for statically-assigned computers, to avoid possible IP conflicts. Launch a web browser from a computer or mobile device that is connected to your router’s network. Defaults may vary by ISP, but the IP address settings based on firmware version are:ģ.5.x and prior (I think Bellsouth models may have used .x version of this): Answer (1 of 5): To log in to your router and access its settings: 1.
0 Comments
Leave a Reply. |